Jg bar 10 upgrades? ?

Question

Can someone plz tell me what I need to upgrade my bar 10 to at least 480 fps

Answer 1

to at least 480 fps?



check out Ed-Gi parts, he sells them from his shop in Hong Kong, very high quality.



or you will need a plethora of other expensive parts..

LayLax Zero Trigger- $160

Tight Bore Barrel- $100

Cylinder set- $180

Hop-Up bucking- $12

Barrel Spacers- $16

Laylax 170sp spring





Spendy Spendy Spendy

Answer 2

I too have heard of EdGI. I hear that those parts are quite good and reliable.



http://www.edgicustom-usa.com/



I just recently upped my TM VSR rifle to about this fps. I currently have

laylax150sp spring

laylax spring guide

laylax red piston

laylax trigger trigger sear

laylax piston sear

laylax spring guide

KM Hop-up bucking

*PDI 6.01mm tightbore barrel*(on its way)

1 set of barrel spacers (made more with electrical tape)



As you can see...I went the Laylax road. There is also the PDI road in which I do not know much of.



I want a Teflon Cylinder...but I don't have the cash yet.

A zero trigger would be nice but again, I don't have the cash.



http://www.airsoftforum.com/board/2008-Vsr-10-Upgrade-Guide-t97319.html



There's a nice guide. a decent start to getting a good rifle.

And no...there is no cheaper way. Yes there is the airbrake mod, but your trigger sears will wear away any way leaving you to buy new ones.

Answer 3

You need a lot of parts to upgrade its power as mentioned above. If just put in a bigger spring the internals will break.